Materials:
Red yarn, cotton, 220 m / 100 g about 10-15 g
A crochet hook
Hollow fiber toy
A thin piece of plastic
2 pieces of hard wire about 3 cm
Clear transparent glue
Gray yarn
Grey/Black polymer clay – small amount for arrow
Brooch base (fastener)
Abbreviations:
ch – chain
sc – single crochet
inc – increase (2 sc in 1 st)
dec – decrease (single crochet two stitches together)
(...) x N times – repeat instructions in brackets N times
Work with red yarn.
Detail 1
1 rnd. 6 sc in Magic Ring
2 rnd. 6 inc (12)
3 rnd. (1 sc, inc) х 6 times (18)
4 rnd. (8 sc, inc) х 2 times (20)
Cut off the thread, fasten. Mark the 2nd loop.
Detail 2
1 rnd. 7 sc in Magic Ring
2 rnd. 7 inc (14)
3 rnd. (1 sc, inc) х 7 times (21)
4 rnd. 20 sc, inc (22)
5 rnd. (10 sc, inc) х 2 times (24)
6 rnd. 22 sc, attach the first detail face down, crochet 2 sc, capturing the loops of the 1st and 2nd details at the same time. (24)
7 rnd. Along the 2nd detail: 10 sc, inc, 11 sc, along the 1st detail: 8 sc, inc, 9 sc (42)
8 rnd. (11 sc, inc) х 2 times, (8 sc, inc) х 2 times (46)
9 rnd. 46 sc
10 rnd. 11 sc, inc, 23 sc, inc, 10 sc (48)
11-12 rnd. 48 sc
13 rnd. 8 sc, dec, 4 sc, dec, 16 sc, dec, 4 sc, dec, 8 sc (44)
14 rnd. 33 sc, dec, 9 sc (43)
15 rnd. 8 sc, dec, 4 sc, dec, 12 sc, (dec, 2 sc)х 2 times, dec, 5 sc (38)
Crochet 1 sc, place a round marker here.
16 rnd. 7 sc, dec, 2 sc, dec, 11 sc, (dec, 2 sc)х 2 times, dec, 4 sc (33)
Attach detail to paper, circle around, drawing down the edge. Cut off the template, transfer to thin plastic. Insert plastic heart inside. Add some hollow fiber. Add it till the end of the crochet.
17 rnd. 8 sc, dec, 11 sc, dec, 1 sc, 2 dec, 1 sc, dec, 2 sc (28)
18 rnd. 6 sc, dec, 2 sc, dec, 7 sc, (dec, 1 sc)х 3 times (23)
Crochet 1 sc, place a round marker here.
19 rnd. 5 sc, dec, 1 sc, dec, 6 sc, dec, 1 sc, dec, 2 sc (19)
20 rnd. 6 sc, dec, 5 sc, (dec, 1 sc)х 2 times (16)
21 rnd. 5 sc, dec, 5 sc, 2 dec (13)
22 rnd. 3 sc, dec, 1 sc, dec, 2 sc, dec, 1 sc (10)
23 rnd. 2 sc, (dec, 1 sc)х 2 times, dec (7)
24 rnd. 1 sc, 3 dec (4)
Cut off the thread. Pull off the loops, hide the tip.
Arrow
Prepare two pieces of thin hard wire about 3 cm. Apply a little glue to half the length of the wire and wrap it with yarn.
Cut any color yarn into 5-6 cm pieces, only 10 parts. Tie knots of yarn at one end of a long wire. Position knots tightly to each other. Look at the photo.
Glue the knots and pieces of yarn with glue. Lay, pointing the ends up. After drying, prune.
Sculpt an arrowhead from grey or black clay. Put on the wire, carefully remove. Bake according to the instructions. Varnish after cooling.
Smear glue the tip of the wire, insert into the arrowhead, glue.
Sew a fastener on the back.
Pierce the heart through with thick needle. Insert glue tips of the wires into the holes. Glue.
Brooch is ready.